Sunday, March 29, 2009

Attaching the Coffee Table Doors


I'm a little behind in my posts. I attempted to attach the six coffee table doors two weeks ago and discovered I hadn't allowed enough room for the swing. The doors would open/close but they would catch on the rail above them. This was bad.


I set up the sanding disc with a coarse grit, tilted the Shopsmith table, and sanded the top back edge of the doors. Some of the doors also needed trimming on the bottom because they were catching the bottom rail. All this set me back a couple weeks because I had to refinish all the doors. The good part is, it gave me a chance to sand down the table top a second time and build the finish coats back up to a smooth glassy surface.


After the rain stopped, Melissa and I brought it in and sat it into its new home, in our family room. The final step will be to add a wax polish to the top. I guess I'll wait a couple weeks to make sure the poly has completely dried.


If my construction was done correctly, this table should withstand the seasonal humidity changes and I'll be able to watch the table top expand and pull away from the breadboard edges.

Sunday, March 08, 2009

Magnetic Door Catches

Yes, I'm still putting coats of finish on the coffee table. I have about one more coat for the doors and most of the table. The table top still needs about 5 more coats. I've been sanding down the top after sets of coats, in an effort to fill the pores and defects with finish. It's nearing a flat top but I think I'm nearing boredom with it so I'm going to end far short of perfection.

Meanwhile, I finally put together the magnetic door catches. They may be cheap, but they're also easy to install and durable. I found a piece of scrap walnut already ripped to match the coffee table rails. So I cross cut 6 pieces on the chop saw. Since there isn't room to get a drill under the bottom shelf, I had to drill and attach the magnetic catches using a straight edge as a guide. The catches have some play that alows for fine adjustment. I can adjust with a stub hand screw driver when I attach the door. I plan to mount the magnetic catch blocks behind the second from bottom rail. I'll use glue and a nail gun. Melissa doesn't like the plastic magnetic catches but they'll be hidden. I don't mind them because I know how difficult other catches are to install.