After noticing one of my wider top panels had cupped, I made another trip to the lumber yard. When I returned, I noticed my newly purchased board came from the same tree as a previous board I had. Cool! I called Brek and asked his opinion on book matching within a table top. He didn't like the idea of two book-matched boards next to a third; said the balance would be off. He suggested ripping the third board and bordering two center book-matched boards. That's what I ended up doing. I think I will appreciate the table so much more if I can always see the book-match and remind myself of my happy accident.
After firming up the table top boards and sides it was time to run them through the jointer. I carefully marked the edges to run each matched edge through the jointer the opposite way. This little trick will ensure matching joints, even if my jointer fence is not perfectly square.
Chamfers - I knew I needed them on this table. People will be moving around chairs and dishes and feet and knees and hands. There would need to be no sharp edges anywhere. So I angled the jointer fence at 45% and ran each edge through twice. I used three passes for each table leg edge to make the chamfers a tad deeper. Deeper leg chamfers will also hopefully deter pets from thinking they can chew a chunk off.
Finally, I screwed my trusty Nobex to the workbench and crosscut the legs and aprons. The Nobex is way more accurate than the table saw. It did suck, making all the cuts in 95 degree Georgia humidy, however.
0 comments:
Post a Comment